---
title: "Starlink Gen2 & Gen3 : Changing the Wi-Fi Network Name and Password"
description: "If your system is equipped with a Starlink router, we strongly recommend that you assign a password to your Starlink’s Wi-Fi network to prevent unauthorized access, unless you are pairing your Starlink system with an antenna system, you may also…"
url: "https://help.globalsatellite.us/docs/starlink-gen2-gen3-changing-the-wi-fi-network-name-and-password/"
updated: "2025-05-26"
category: Starlink
---

# Starlink Gen2 & Gen3 : Changing the Wi-Fi Network Name and Password

If your system is equipped with a Starlink router, we strongly recommend that you assign a password to your Starlink’s Wi-Fi network to prevent unauthorized access, unless you are pairing your Starlink system with an antenna system, you may also change the name (SSID) of the network. Follow the steps below.

**Step 1:**

- Connect your mobile device to the **STARLINK** or **STINKY** Wi-Fi network (no password).

**Default Starlink Wi-Fi Network Connection**

![](https://help.globalsatellite.us/wp-content/uploads/2025/03/Image22.png)

***If you do not see this network, perform a factory reset of the Starlink router:***

**Starlink Gen 3 Router Factory Reset Button**

![](https://help.globalsatellite.us/wp-content/uploads/2025/03/Image33.jpg)

**Starlink Gen 3 router:** Remove the rubber cover protecting the Ethernet ports on the rear panel. Then, using a paper clip (or equivalent), press and hold the Reset button located between the two Ethernet ports for 2-3 seconds. *The light on the front of the router will blink fast for a few seconds then blink slowly for a couple minutes while the router initializes.*

**Starlink Gen 2 Router Power Cable Connection**

![](https://help.globalsatellite.us/wp-content/uploads/2025/03/image.jpeg)

**Starlink Gen 2 router:**Cycle power (unplug then plug back in the AC power cord) on the router six times in a row, allowing 2-3 seconds between power cycles. Then wait a few minutes for the router to initialize.

**Step 2:**

- Open a web browser and go to **192.168.1.1**. You should see “Starlink Create Network.”

**Starlink Create Network Page**

![](https://help.globalsatellite.us/wp-content/uploads/2025/03/Image1-1-809x1024.png)

**Step 3:**

- Enter a new name and password for the Starlink Wi-Fi network. Then select **CREATE**. A confirmation screen will appear.

**Confirmation Screen**

![](https://help.globalsatellite.us/wp-content/uploads/2025/03/image.png)

**Step 4:**

- Reconnect to the Starlink Wi-Fi network using your new network name and password.

**Connection to Renamed Starlink Wi-Fi Network**

![](https://help.globalsatellite.us/wp-content/uploads/2025/03/Image11.png)
